Use and Care Manual

49-5000444 Rev. 2 13
Installation Instructions
INSTALLATION INSTRUCTIONS
Whirlpool (23” Deep)
4
4
3
8
3
8
1. 5HPRYHH[LVWLQJUHDUJULOOHDVVKRZQRQSDJHRIWKLV
manual and replace with provided louvered rear panel.
NOTE: <RXPD\QHHGWRGULOOKROHVLQIODQJHRIH[LVWLQJ
sleeve to match new rear grille.
Because of the increased unit depth, first try dry
fitting using the method described below:
3ODFH´[´[´VHDOVDJDLQVWHDFKVLGH
*HQWO\VOLGHXQLWLQDQGFKHFNLIDPRXQWH[WHQGLQJ
from the sleeve is sufficient once the trim frame is
attached.
4. If position is correct, remove unit and proceed to the
QH[WVWHS,IQRWJRWRVWHS
$WWDFK´[´[´ORQJVHDOLQWKHFHQWHU
at the top of the sleeve. Remove the backing paper
and press into position.
$WWDFK´[´[´VHDOVWRWKHOHIWDQGULJKW
sides of the sleeve.
&XW´[´[´VHDOVWR´ORQJDQGDWWDFK
them to the vertical sections of the grille.
8. Attach the tapered spacer blocks to the floor of the
sleeve. Now go to step 15.
Use these next steps if the unit requires extra
extension into the room:
$WWDFK´[´[´ORQJVHDORYHUWKHVROLGYHUWLFDO
portion of the rear grille.
$WWDFK´[´[´IRDPEORFNVZLWK
the slot overlapping the seal above.
11. Install the divider into the slots of the foam blocks.
You may need to trim the length to size.
12. Repeat steps 9-11 for the other vertical portion of
the grille.
$WWDFK´[´[´VHDOVDORQJWKHVLGHVRI
the sleeve again making sure all seals are flush.
&XWWKH´[´[´VHDOWRILWWKHWRSRIWKH
sleeve. The pieces must be fitted flush to the edge
of the divider.
15. Center unit and gently slide unit into sleeve.
16. Before sliding all-the-way back, remove the first
screw from front on left side of unit.
Whirlpool (23” Deep) continued
17. Remove the plastic washer from the screw.
18. Screw and attach the other end of the ground
wire to the unit. Make sure that the toothed
washer is against the cabinet.
19. Slide the unit completely to the rear to ensure a
good seal, making sure the ground wire does not
become tangled.
20. If you have difficulty with mounting the grill to the
sleeve, follow the instructions for direct mounting
on page 15.
21. Seal and frame the unit as described on page 16.