User Manual

19
3. If “EXIT” is clicked, the aircraft will exit the Dronie mode and hover in its current position.
Rocket
Operating steps:
1. Click the smart function button “ ” in the GDU Mini App flight interface. Select “Rocket”
in the pop-up interface to enter the Rocket mode.
2. The user should set the flight distance, select video or photo mode along with the control mode,
and then click “Start flight”. The aircraft will rise vertically, and the target will be shot vertically.
After shooting, the aircraft will return and hover in place, as per the settings.
3. If “EXIT” is clicked, the aircraft will exit Rocket mode and hover in its current position.
Propellers
The GDU O
2
system is provided with folding propellers divided into Type A and Type B,
corresponding to the different rotational directions of the motor.
Propeller
Type A
Type B
Schematic
Diagram
Installation
location
On the clockwise rotating motor
shaft
On the counterclockwise rotating
motor shaft
Propeller Disassembly
The base of blade, the motor, and the arm’s inner surface are marked with either A or B. The letters
on these three parts must match during the installation process.
The process of propeller installation is as follows. First, select the same type of propeller as per the
letter on the motor. With the letter facing upwards, press the blade into the clamp. Then press the
clamp into the slot of the motor shaft, and turn the Type A propeller leftwards 45 degrees and the
Type B propeller rightwards 45 degrees, until the holes at the two ends are aligned with the stop pins.