Use and Care Guide

□
□
□
□
□
□
6
13
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Assembly - Standard Ceiling Mount
Wiring the receiver
Connect the receiver as shown in the
wiring diagram.
Follow the steps below to connect the
fan to your house supply wires.
Connections between the motor
assembly and the receiver:
Butt slice the white terminal on the
fan to the white terminal on the
receiver with the Orange/Grey/White.
Butt slice the black terminal on the
fan to the black terminal on the
receiver.
Butt slice the terminal on the fan to
the blue terminal on the receiver.
The receiver is connected to your
home's power cord.
Use the wiring cap (AA) to connect the
black wire harness with the "L" logo
on the receiver to your home's Hot.
Use the wiring cap (AA) to connect the
white wiring harness with the "N"
mark on the receiver to the Natural at
home.
If your outlet box has a GROUND wire
(Greenor Bare Copper), connect this
wire to the Hanger Ball and Mounting
Bracket and receiver Ground wires.
If your outlet box does not have a
Ground Wire, then connect the Hanger
Ball and Hanger Bracket and Receiver
Ground Wires together.
After all the splices are made, check
to make sure there are no loose
strands or wires.
A
F
MM
AA
Yellow Green
Yellow Green
Yellow Green
Ground conductor
Yellow Green
Yellow Green
Blue
Blue Red
Blue Red
Red
Grey
Hot
Black
L
Black
Black
Black
Black
White
Black White
White
White
Orange
GreyOrange
Neutral
White
N
White