User Manual

- Enter the name in ‘Device Name’ that you want to identify the IP Doorbell (e.g.
FrontDoor). This name will be specific to the App of each mobile device. *You
may not use spaces or other special characters in the name on Android devices.
- Enter the ‘User Name’ (default is ‘admin’).
- Enter the ‘Password’ (default is ‘1234’).
- Tap ‘Done’.
- Re-enter the device settings and ensure the ‘Outdoor call-in’ is turned on.
- *After correct configuration it may take a few moments for the IP Doorbell to
make the initial connection through the cloud service.
- *Unlock Password can be changed in the App as well as through the Web Browser
Interface. This will change the password for all users of the IP Doorbell. It also
changes the password required in the device settings. You may need to update the
password in the device settings of the ControlCam App in each mobile device.
5. Keypad Programming (PL960PM Model)
The PL960PM keypad can be custom programmed with up to 40 different access codes,
and will trigger the same relay that is triggered through the ControlCam App. The length
of the access codes and programming password can be programmed to be 2 to 6 digits in
length (globally). However, the master password and unlock delay times set in the keypad
are independent of the IP Doorbell. A factory reset of the IP Doorbell will not affect the
programming contained in the keypad, and vice versa. The keypad requires a separate
factory reset to clear the programming.
- Modify the Programming Password
o Disconnect power to the IP Doorbell.
o While pressing the ‘*’ button, restore the power to the IP Doorbell. Two
short chirps will be heard.
o Continue holding the button until the IP Doorbell starts chirping
continuously. Release the button.
o Enter the new password (length determined by other programming). A
longer beep is heard, indicating the new password has been successfully
stored.
o Press’*’ to exit the programming mode.
- Enter Programming Mode
o Press the ‘*’ button, a chirp is heard.
o Enter the programming password (default is 1234). A longer beep is heard,
indicating the IP Doorbell is now in programming mode.
o The IP Doorbell will automatically exit programming mode if there is no
input at the keypad for over 30 seconds, or press ‘*’ to exit programming.
- Set Unlock Duration Time
o Enter programming mode.
o Press ‘00’, a longer beep is heard.
o Enter 2 digits (01 – 99) representing the new unlock duration time, in
seconds. A longer beep is heard confirming the change.