Manual

Page 5-1
Operating Instructions
27C
TOP FILM SUPPLY SHAFT
Holds the film supply on the laminator.
RELEASE LINER TAKE-UP
Rewinds the release liner of pressure sensitive films.
IDLER BAR
(Not shown.) The idler bar directs the film to the
roller.
PRESSURE ROLLERS
Two pressure rollers apply pressure to the film and
the print being laminated or mounted. They pull the
print and films into the laminator.
NIP POINT
(Not shown.) The point at which the top and bottom
rollers come into contact and the point at which the
items for lamination are introduced into the laminator.
SAFETY SHIELD
The safety shield prevents entanglement,
entrapment, and inadvertent contact with the rollers.
When the safety shield is removed, the laminator
runs at 3 fpm (0.9 m) when you press the RUN
button. The safety shield is removed only when you
load films.
WARNING: Keep your fingers and hands away
from the nip point. Failure to observe this warning
could result in severe personal injury.
5. FEATURE GUIDE
Fig. 5-1. 27C Laminator Identification.
This chapter helps you identify the main components of the laminator.
Safety shield
Feed table
Top film supply shaft
Bottom supply shaft
Release liner take-up
Roller pressure
handle
Feed table
interlock latch
(under table)
Pressure roller
Control panel