User Manual

getting ready to laminate

Easy Set Up

1 Take the electrical plug and place in an appropriate power source, which is near the table you

intend to use.

2 The laminator will respond with a single beep and a sequence of brief ashes across the control

panel.

3 To use the laminator move the slider to the right from the ‘

’ to the 3 mil or 5 mil position

depending on which pouch selected. Below the slider you will see a white line, this indicates that

you have switched the laminator on.

loading the pouch

1 Take your item to be laminated and place in to the appropriate sized laminating pouch,

ensuring it is rmly located along the sealed edge. This is to help ensure that you get optimal

quality output.

Before laminating important or unique documents, always run a test pouch through

the laminator using a similar type document.

SEALED EDGE

letter, menu, photo Irregular shaped item

SEALED EDGE

NOTE: Do not cut pouches prior to

lamination.

a b

NOTE: Your new laminator may emit a slight

odor during the initial operation. Its is

normal and will diminish after a few

hours of operation.

NOTE: Only use 3 mil/5 mil photo pouches

Visual & Audible Ready Alerts

4 The laminator will start to warm up - an orange light will be illuminated to the right of the ‘

’ (a).

When the laminator is ready to use the green light next to the ‘tick ’ is illuminated (b) and a

series of two beeps are heard.

English