Operation Manual

80
53
52
1
2
51
54
55
Connecting the motor cable
• Makesurethatyouhaveremountedthefront
wheel to the bike in accordance with the instructions.
• Makesurethatthecablefromthemotoraxlefalls
into the front fork’s recess at the underside, or else
you will damage the motor cable.
• Makesurethatthemotorcableisclampedbehind
the 2 cable guide brackets and firmly press the
cable to the recess in the front fork. (Photo 51)
• Reconnectthetwoendsandrefitthetransparent
crimp sheath. Fit a new, small cable tie to the lower
section of the crimp sheath to ensure it remains
watertight, and refit the cables in the connector
casing. (photo 52)
• Feedboththeupperandlowersectionsofcable
behind the securing clips (1 and 2). (photo 53)
• Whenareplacementismade,youmustalso
replace the pull tie. This is necessary to guarantee
water tightness.
• Attachthefrontpartofthecapwiththe2Allen
screws. Make sure that the two halves connect
properly and that no cables interfere.
(Photos 54 + 55)
• Slidethebatterybackintothebikeandcheckif
the display is working.