Operation Manual

The battery
69
17
15
16
Charging the battery separate from the bike:
• Complywiththeabovecharginginstructions.
• Removethebatteryfromthebikeinaccordance
with the previously given instructions.
• Putthebatteryonaflat,hardsurfaceinthevicinity
of a power socket.
• Opentherubbercovercapofthebatterycharge
plug, on the rear left at the taillight, and put in the
power plug of the charger.
(Photo 15)
• Makesurethatthepowerplugsitsfirmlyinthe
battery.
(Photo 16)
• Putthepowerpluginthesocket.
• TheLEDintherearlightflasheswhenyouconnect
the charger correctly. On the charger itself a green
light will be on, indicating that the charger is in use.
• TheflashingLEDdisplaysthebattery’slevelof
charge. The LEDs start on the far right and move
totheleft.EachLEDindicatesapproximately20%
of a full charge. When the LED at the far left is
flashing, the battery is nearly fully charged.
(Photo 17)
• Ifyouarefinishedcharging,firstremovethepower
plug from the battery and put the cover cap back
over the charge plug. Then take the power plug from
the charger out of the socket.