Operation Manual

68
14
Charging the battery in the bike:
• Complywiththeabovecharginginstructions.
• Parkthebikesolidlyonitskickstandinthevicinityofa
power socket.
• Opentherubbercovercapofthebatterychargeplug,on
the rear left at the taillight, and put in the power plug of
the charger.
• Putdownthechargersecurelyandputthepowerplugin
the socket.
• IfaLEDlightbulbinthetaillightstartsflickering,you
have properly connected the charger.
• TheflashingLEDdisplaysthebattery’slevelofcharge.
The LEDs start on the far right and move to the left. Each
 LEDindicatesapproximately20%ofafullcharge.When
the LED at the far left is flashing, the battery is nearly
fully charged. (photo 14)
• Ifyouarefinishedcharging,firstremovethepowerplug
from the battery and put the cover cap back over the
charge plug. Then take the power plug from the charger
out of the socket.
• NotallbatteriesdisplayflashingLEDswhencharging.To
check the level of charge of these batteries, briefly press
the button on the rear light. The position of the flashing
LED indicates how full the battery is.
i Once or twice a year, ride around until the battery is
completely discharged. This is because completely
discharging and then recharging the battery has a
positive impact on its operational life.