Installation Guide

ZZZ-187.W1608MR.0529-20.GP.EN.doc WEB VERSION

ASSEMBLE PIECES

BEFORE SCREWING

THEM TO THE WALL

STEP #4

Set polycarbonate exposed side on the outside over horizontal left guide I-3, use one (1) Rr-3 panel, one (1)

P-3 joint and one (1) Ss-3 panel, then do the right side with one (1) Tt-3 panel, one (1) Q-3 joint and one (1)

Uu-3 panel over the J-3 horizontal guide. Secure P-3 and Q-3 to I-3 and J-3 respectively with self-tapping

screws (PQ-3).

NOTE:

Once the wall track is in place,

apply silicon along the top of the

wall track and at the joint of the

two tracks.

Silicon is not supplied.

STEP #3

Assemble ML-3, O-3, N-3, and MR-3 as shown

and position evenly above vertical guides, at 96’’

from the ground. Secure wall track and vertical

tracks to brick or cement wall by drilling through

the aluminum and using screws Xx-3. Insert the 2

horizontal guides, I3 & J3 at the top of the frame.

Make sure the 2 frames are at the correct level, if

not, use shims to compensate. Do not use tools to

force.