Installation Guide

ZZZ-187.W1608MR.0529-20.GP.EN.doc WEB VERSION

TOOLS REQUIRED:

 Screwdriver (Philips #2)

 Knife

 File (smooth)

 Needle-nosed pliers

 Rubber mallet

 Step ladder (minmum 6' in height)

 Spatula

 Power drill

 Tube of silicon

 Drill bit 5/16" cement

(according to surface)

 Round file + flat

 2”x4”x8” wood

BEFORE STARTING:

Ensure that you have a solid base,

such as concrete or wooden deck,

not slanted more than 1” per 8’. Avoid

installing unit adjacent to trees or a sloped

roof, as snow and ice may slide onto the

solarium and cause it to collapse.

Please don't destroy boxes until completely assembled.

STEP #1

Decide the position of the door frames before assembly according to where you intend to slide the door. At

the front of the solarium, use frame D3 for the opening of the door and B3 for the direction of the door when

open. Use E3 between frame ends and use two (2) K3 joints for corners.

Look for the sticker that will show you which side is up. (See sketch on page 14)

NOTE:

When sliding the connectors,

shake the frame so that they

will slide easily. Do not use

tools to force. If needed, clean

the paint with a file and make

sure the ends of the frame and

joints are not bent or warped.

If so, use the needle-nosed

pliers to straighten.

STEP #2

Slide the vertical guides Vv-3

left and Ww-3 right into the 2

ends of the frames along the

grooves, shaking while sliding

for easier movement.