436586 GRILL GAZEBO INSTALLATION MANUAL DO NOT DESTROY THE BOXES UNTIL COMPLETELY ASSEMBLED PLEASE VERIFY THE CONTENT OF EACH BOX AGAINST THE LIST OF PARTS Two or more adults required for assembly Base Dimensions 6’10 ½” x 4’11 ¼”; Largest Dimensions 7’10” x 4’11 ¼” 436586.0817-18.EN.
Before Assembly: - Please don't destroy boxes until completely assembled. - Please verify the content of each box against the list of parts. - Read instructions and check that all parts are present in the boxes. If any parts are missing, refer to warranty information on pg. 10. - Assembly will require at least two persons and 2 hours. - A stepladder will be required for assembly. - The gazebo should be assembled on a level, flat surface.
Step 3: Attach the rear bars (G) between legs (A & B) using 2 bolts (Z) at each end. Then install the central bar (G-1) at the center of the two rear bars, using bolts (W). 436586.0817-18.EN.
Step 4: Attach the bottom side bars (H) at the bottom between legs (A & C) and (B & D) using bolts (U). Attach the top side bars (I) at the top between legs (A & C) and (B & D) using bolts (Z). Attach the top bars (J) between legs (A & B) and (C & D), again using bolts (Z). 436586.0817-18.EN.
Step 5: Screw shelf brackets (K-1) to the bottom of the shelf (K) on each side, using bolt (Aa) and locknut (Aa-1). Then attach the shelves and shelf brackets between the left legs (A & C) using bolts (Z). Screw cloth holder brackets (L-1 & L-2) to the cloth holder (L) using bolts (Z). Then attach them between the right legs (B & D), also using bolts (Z). Step 6: For the upper roof, lay out edge rafters (M & M-1), two edgings (O), roof panels (P), and rafters (Q), as shown in diagram.
Step 7: Bend and slide roof panel (P) into one corner, then insert rafter (Q) next to it, attaching the ends to the edging (O) with bolts (Cc). Add the next roof panel (P), then another rafter (Q) in the same manner. Insert the final roof panel (P), and then close the upper roof with the previously assembled corner (M & O), using roof connectors (R) at the corners and bolts (Cc).
Step 9: Attach roof supports (S) to the center of each top bar (J) using one bolt (V) each. Attach the lower roof assembly to the roof supports (S) using bolts (W), and to the top of legs (B & D) using 2 bolts (Y) per leg. Attach the upper roof assembly to the plate on lower rafters (N & N-1) using bolts (Z), and to the top of legs (A & C) using 2 bolts (Y) per leg. Step 10: Anchor the unit to the ground through the bases (E).
(12-051) BACK LEFT LEG A 1 (12-052) BACK RIGHT LEG B (12-053) FRONT LEFT LEG C 1 1 DESCRIPTION PACKED IN BOX 1 (14-064) TOP BAR J 1 2 1 (12-063) LOWER SHELF K 3 2 1 (12-064) SHELF BRACKET K-1 1 4 1 1 1 1 1 1 1 1 1 1 1 1 1 1 (12-054) FRONT RIGHT LEG D 1 1 (12-055) BASE E 1 4 (12-056) TOP SHELF F 3 2 (12-057) SHELF SUPPORT BAR F-1 1 2 (12-058) REAR BAR G 1 2 (12-059) CENTRAL BAR G-1 1 1 (12-060) BOTTOM SIDE BAR H 1 2 436586.0817-18.EN.
(12-061) TOP SIDE BAR I (12-073) 54 DESCRIPTION PACKED IN BOX 2 (12-072) EDGING O 1 4 2 3 (12-081) BOLT V 1 4 2 3 (12-082) BOLT W 1 2 1 2 (12-083) BOLT X 1 8 1 2 (12-084) BOLT Y 1 8 1 8 (12-085) BOLT Z 1 40 (08-158) BOLT Aa 1 1 DRAWING ¾” x 19” UPPER ROOF PANEL P (12-074) 48” x 19” LOWER ROOF PANEL P-1 (12-075) UPPER RAFTER Q (12-076) LOWER RAFTER Q-1 (12-077) ROOF CONNECTO R R (12-078) ROOF SUPPORT BAR S QTY PACKED IN BOX QTY DESCRIPTION 1 2 M6x40mm M6x35mm M6
DRAWING DESCRIPTION PACKED IN BOX M6x70mm (12-087) BOLT Cc 1 QTY PACKED IN BOX QTY DESCRIPTION (08-161) BOLT U 1 (12-089) ACORN NUT U-1 1 4 (08-181) ALLEN KEY 1 1 (08-187) WASHER U-2 1 4 (12-088) NAIL Dd 1 4 436586.0817-18.EN.
MAINTENANCE NOTES 1. In case of a defective or damaged part, or for any other questions concerning the product, please contact the manufacturer directly. 2. Please have the parts list and part numbers on hand when ordering or requesting replacement parts. 3. The product should not be installed adjacent to trees or a sloped roof. Snow and ice may slide onto the roof and cause it to collapse. 4. While the product is designed for 4 seasons use, the roof must be kept free of accumulation of snow.
