Installation Guide

5
ZZZ-204.43224.1207-18.GP.EN.SUN WEB VERSION SUN-HI
Step 9:
Slide the indicated polycarbonate
panels into the spaces between the
rafters, using the top groove of
each rafter. Ensure the side meant
to face the sun is on the outside.
Use a rubber hammer to carefully
tap each panel into the grooves.
Step 10:
Insert the middle roof joints in between the rafters and slide them up under the polycarbonate panels.
Tap lightly to ensure the panel is fully in the slot. Seen from above, most of the joint as well as the
drain holes should be beneath the roof panels.
To adjust the middle joints to line up : once all polycarbonate roof panels are in place, use a small
piece of wood and hammer, then tap down on the middle of the joint bringing it down and holding at
the same time the joint and top polycarbonate.
Do not tap too hard.