Installation Guide

ZZZ-212.43200.0114-21.GP.EN.doc WEB VERSION 10
Step 9:
1. Slide the indicated polycarbonate
panels into the spaces between
the rafters, using the top groove
of each rafter.
2. Ensure the side meant to face
the sun is on the outside. Use a
rubber hammer to carefully tap
each panel into the grooves.
Step 10:
1. Insert the middle roof joints in
between the rafters and slide them up under the polycarbonate panels. Tap lightly to ensure
the panel is fully in the slot. Seen from above, most of the joint as well as the drain holes
should be beneath the roof panels.
2. To adjust the middle joints to line up : once all polycarbonate roof panels are in place, use a
small piece of wood and hammer, then tap down on the middle of the joint bringing it down and
holding at the same time the joint and top polycarbonate.
Note: Do not tap too hard.