Vogue Inset Front For use with Gazco Logic HE Instructions for Use and Installation For use in GB, IE (Great Britain and Republic of Ireland) PR2562 Issue 3 (May 2019)
Installation Instructions Covering frame model numbers: Vogue Inset Front Logic HE 901-398 1. General 1.1 These instructions are supplementary to, and must be read in conjunction with, the instructions supplied with the appliance. Read both thoroughly before installation. 1.2 The Vogue Inset front comes as a kit and fitting should be carried out after the appliance has been installed and commissioning tests completed. 1.
Installation Instructions 2. Pre-Installation 2.1 The front consists of the following components: 3. Fitting the Sub-Frame 3.1 — Sub-frame Main Assembly — Sub-frame Cast Top — Decorative Cast Iron Door Assembly — Cast Control Cover — 2 x Fixing Screws Complete the installation of the Logic HE by following the installation instructions supplied with the appliance. Slide Control Models only: Caution: Take care not to damage the slide control handle during installation.
Installation Instructions 3.4 3 Locate the top edge of sub-frame onto the tabs found at the top of convector box and push down firmly to ensure correct fitting, see Diagram 3. Slide Control Model 4. Fitting the Vogue Inset Front Slide Controls Models only 4.1 Remove the cast infill from the front by unscrewing the 2 screws. This provides a cutout for the slide mechanism, see Diagram 5. 5 3.5 Secure the sub-frame to the bottom of the appliance with the 2 fixing screws provided, see Diagram 4.
Installation Instructions All Models 4.2 Rest the bottom fixing hooks into the bottom locating slots. Lift the upper frame fixing hooks into the top locating slots and lower into final position, see Diagram 7. 7 4.3 To fit the control cover: Locate the fixing hooks into the locating slots and lower into final position, see Diagram 7. 5. Cleaning and Controls Ensure the appliance is cold before attempting to clean the front. 5.1 Do not use abrasive cleaners. 5.
Gazco Limited, Osprey Road, Sowton Industrial Estate, Exeter, Devon, England EX2 7JG Technical Customer Services (01392) 261950 Fax: (01392) 261951 E-mail: technicalservices@gazco.
