Balanced Flue Instructions

User Instructions

7. Log Layout

LOGS MUST BE POSITIONED ACCORDING TO THE

FOLLOWING INSTRUCTIONS TO GIVE THE CORRECT

FLAME EFFECT.

Small Vision Layout

All logs can be identified by a letter (A - E) on their

underside. Logs B and E also have holes to locate each

onto a burner stud.

7.1 Ensure the burner tray is clean and free from any debris,

see Diagram 6.

7.2 Place Log A on the higher rear bracket and push up against

the back panel, see Diagram 7.

7.3 Place Log B over the two middle studs on the burner tray,

see Diagram 8.

7.4 Place Log E onto the stud and behind the tag on the left

hand side of the burner tray.

Rest against Log B, see Diagram 9.

7.5 Place the small Ember at the front left of the firebox, against

the rear of the log support bracket to obscure the reflection

of the burner screw.

Place the larger Ember on the lower bracket above the pilot

on the right hand side with the thicker edge facing the front

and flat edges to the base and side, see Diagram 10.

7.6 Log C rests on the cutout on Log E and is pushed up to the

side and rear of the firebox, see Diagram 11.