Balanced Flue Instructions

All Models

2.2 Remove the glass front to gain complete access to the control

valve and the viewing aperture by lifting the hooks clear of the

slots on the front of the appliance, see Diagram 2.

3. Window Frame Assembly

3.1

Using screwdriver remove the eight screws securing the

window panel to the appliance, see Diagram 3.

Take care to support the glass when removing the screws.

3.2 Place carefully to one side.

3.3 The glass frame must be refitted to the appliance following

cleaning or servicing. Hold in position and secure with the

screws.

3.4 Replace ALL of the securing screws ensuring that a screw is

present in all fixing slots.

UNDER NO CIRCUMSTANCES SHOULD THE

APPLIANCE BE USED IF ANY OF THE GLASS

FRAME RETAINING SCREWS ARE LOOSE OR

MISSING.

1. General

1.1 All main components can be replaced without removing the

appliance from its installation.

IT IS ESSENTIAL THAT THE GAS SUPPLY TO THE

APPLIANCE IS TURNED OFF AT THE ISOLATION

DEVICE BEFORE PROCEEDING FURTHER.

1.2 Removal of Flue

If, for any reason, the flue has to be removed from the

appliance, the seal must be replaced in the inner spigot.

2. Decorative Front

IMPORTANT: THE OUTER PANELLING OF THE

VISION IS MADE FROM GLASS. USE CAUTION

WHEN INSTALLING, REMOVING AND STORING AS

THE COMPONENTS ARE FRAGILE AND COULD

BREAK UNLESS HANDLED CAREFULLY.

2.1 Remove the glass plinth to access the controls:

Small

Lift the hooks clear of the slots on the front of the appliance

and lower so that the tab on the glass plinth clears the glass

front, see Diagram 1.

Midi & Medium

Lift the hooks clear of the slots on the front of the appliance,

see Diagram 1.

Midi & MediumSmall

Servicing Instructions - Replacing Parts