Balanced Flue Instructions

29
9.22 Place the log guard into position on the grooves on the
sides of the firebox, see Diagram 38.
38
9.23 Place Log A across Log C. There is a hole on the underside
of Log A which fits over the raised stud on Log C to secure
in place. The small cut out on the left side of the log rests
onto the log guard, see Diagram 39.
39
9.24 Once the logs are in place use some of the Embaglow wire
wool provided and cover the ports in the burner tray with a
liberal amount of fibres, in the highlighted areas shown in
Diagram 40.
NOTE: It is not necessary to use all of the Embaglow.
IT IS ESSENTIAL TO KEEP THE REAR PORT FREE
FROM OBSTRUCTION.
40
Keep Rear
Port free from
Embaglow
Installation Instructions
10. Completion of Assembly
10.1 To fit the glass frame
Offer the panel to the foot of the opening and secure using 8
screws as shown, see Diagram 41.
41
10.2 Replace ALL of the glass frame securing screws ensuring
that a screw is present in all fixing slots.
UNDER NO CIRCUMSTANCES SHOULD THE
APPLIANCE BE USED IF ANY OF THE GLASS
FRAME RETAINING SCREWS ARE LOOSE OR
MISSING.
10.3 Fit the glass front by inserting the hooks on the back of the
frame into the slots on the front of the appliance, see
Diagram 42.
42