Balanced Flue Instructions

Installation Instructions

Midi Vision Layout

9.10 Ensure the burner tray is clean and free from any debris,

see Diagram 26.

The three logs that make up the fuel bed are visually distinct

and fit into specific parts on the burner tray.

9.11 Place the rear log into position between the rear brackets

and pushed up against the back panel, see Diagram 27.

Log 1

9.12 Place the second log into the left hand groove on the burner

tray, see Diagram 28.

The log should butt up against the raised molding and the

left hand side liner.

Log 2

9.13 Place the third log into the groove on the right hand side,

see Diagram 29 .

The log should butt up against the raised molding and the

right hand side liner.

Log 3

9.14 Once the logs are in there are two embers which can be

loosely placed at the front of the fuel bed and cover the tabs

securing the burner tray, see Diagram 30.

Embers

9.15 Use some of the Embaglow provided and cover the ports in

the burner tray with a liberal amount of fibres,

see Diagram 31.

It is essential to cover the port in the middle of the

burner tray in order to get the most visually appealing

flame picture.

NOTE: It is not necessary to use all of the Embaglow.

It is essential to

cover the

central port

Embaglow