Balanced Flue Instructions

26
9.4 Place Log E onto the stud and behind the tag on the left
hand side of the burner tray.
Rest against Log B, see Diagram 20.
20
9.5 Place the small Ember at the front left of the firebox, against
the rear of the log support brcket to obscure the reflection of
the burner screw.
Place the larger Ember on the lower bracket above the pilot
on the right hand side with the thicker edge facing the front
and flat edges to the base and side, see Diagram 21.
21
9.6 Log C rests on the cutout on Log E and is pushed up to the
side and rear of the firebox, see Diagram 22.
22
Installation Instructions
9.7 Place the pointed bottom of log D into the corner of the
burner tray and rest on the location stud on log B see
Diagram 23.
23
9.8 Use some of the Embaglow provided and cover the ports in
the burner tray with a liberal amount of fibres. Use a small
piece in front of the log on the left hand side and a long strip
in front of log B, see Diagram 24.
NOTE: It is not necessary to use all of the Embaglow.
Embaglow
24
9.9 Lower log guard into position, see Diagram 25.
25