Balanced Flue Instructions

21
Installation Instructions
3.6 Lift the appliance so as to locate the key slots in the carcass
onto the fixing screws. There are two large holes the lower
flanges on the front edges of the base, see Diagram 4.
Wingnut
Washer
Key slots
4
3.7 Place the two large washers over the studs and fix with two
wingnuts, see Diagram 4.
4. Fitting the Top Plate
4.1 The Vision has a decorative plate that sits on top of the
outer box. Depending on the choice of flue exit this top will
have a hole for the flue pipe to pass through or be
completely smooth.
The hole will be situated in an off set position to the rear
edge of the glass top.
When installing the spigot must be put in place before the
glass top is located. Then the connection to the flue can be
made.
4.2 To fit the top line up the raised fins on the underside of the
glass plate with the cut outs in the top of the box, see
Diagram 5a & 5b.
Rear Exit
Fins
Cut Outs
5a
Top Exit
Cut Outs
Offset edge
to rear
Fins
5b
All Models
3.2 Remove the glass front to gain complete access to the control
valve and the viewing aperture by lifting the hooks clear of the
slots on the front of the appliance, see Diagram 2.
2
Small & Midi only
SECURING THE APPLIANCE
The appliance sits on a mounting bracket to secure it in
place to either the hearth or bench.
3.3 Position the appliance:
Loosely attach the bracket to the appliance and place
centrally on the hearth OR in the desired position on the
bench. Remove the appliance leaving the bracket in the
correct position and mark the holes to drill the bracket
screws, see Diagram 3.
Bracket
3
Small & Midi only
3.4 Remove the bracket and drill the guide holes.
3.5 Fix the bracket either to the hearth or the bench, see
Diagram 3.
NOTE: Use the wood screws and rawl plugs in the fixing
kit supplied for hearth mounting installations and the
self tapping screws for installation onto a bench.