Balanced Flue Instructions

7.19 Place Log D on the left hand side of the burner. There is a

hole on the underside of Log D which fits over the raised

stud on the left of the burner. The back of the log should rest

flat against the back panel, see Diagram 24.

7.20 Place Log B on top of Log D. There is a hole on the

underside of Log B which fits over the raised stud on Log D

to secure in place. The right hand side of the log rests in the

groove in the burner, see Diagram 25.

7.21 Place Log C on the right hand side of the burner. There is a

hole on the underside of Log C which fits over the raised

stud on the right of the burner. The back of the log should

rest flush against the back panel, see Diagram 26.

User Instructions

7.22 Place the log guard into position on the grooves on the

sides of the firebox, see Diagram 27.

7.23 Place Log A across Log C. There is a hole on the underside

of Log A which fits over the raised stud on Log C to secure

in place. The small cut out on the left side of the log rests

onto the log guard, see Diagram 28.

7.24 Once the logs are in place use some of the Embaglow wire

wool provided and cover the ports in the burner tray with a

liberal amount of fibres, in the highlighted areas shown in

Diagram 29.

NOTE: It is not necessary to use all of the Embaglow.

IT IS ESSENTIAL TO KEEP THE REAR PORT FREE

FROM OBSTRUCTION.

Keep Rear

Port free from

Embaglow

7.25 Once the fuel bed arrangement is complete, replace the

glass frame and secure, see User Section 5.