Logic HE Conventional Flue Combined Controls Installation User Instructions

7
User Instructions
3. Changing the Battery
Remote Control
3.1 The battery box is located at the bottom left of the appliance
behind the ash cover.
3.2 Remove the old batteries and replace with a new high
quality (Duracell or similar) 4 AA batteries.
7
It is essential to use high quality batteries (Duracell
or equivalent) when replacing batteries.
Slide Control
3.3 The battery box is located at the bottom left of the appliance
behind the ash cover, see Diagram 8.
8
9V Battery
Ignition
Unit
3.4 Remove the old battery and replace with a new high quality
(Duracell or similar) 9V battery.
It is essential to use high quality batteries (Duracell
or equivalent) when replacing batteries.
4. Cleaning the Appliance
4.1 Make sure the appliance and surrounds are cool before
trying to clean.
4.2 Refer to the separate decorative front instructions to remove
the front from the appliance.
4.3 Remove the glass frame by unscrewing the 4 screws in the
retaining bracket, see Diagram 9.
Detail A
A
9
4.4 Lift the glass frame off the lower location tabs, see Diagram
9, Detail A and carefully place to one side.
4.5 To clean the glass surface, Gazco recommends you use hot
soapy water.
4.6 The glass frame must be refitted to the appliance following
cleaning or servicing.
Ensure that the fibre glass seal on the box is intact, then
lower the glass frame into the lower location tabs on the
box. The tabs should locate between the glass and the
decorative front, see Diagram 9, Detail A.
4.7 Secure the glass frame using 4 screws in the retaining
bracket, see Diagram 9.
Replace ALL of the securing screws ensuring that a screw
is present in all fixing slots.
NEVER OPERATE THE APPLIANCE WHEN THE GLASS
FRAME IS REMOVED OR BROKEN.
Refer to the separate decorative front instructions to replace
the front on the appliance.
UNDER NO CIRCUMSTANCES SHOULD THE
APPLIANCE BE USED IF ANY OF THE GLASS
FRAME RETAINING SCREWS ARE LOOSE OR
MISSING.
White Stone Effect
4.8 Remove the white stones and place on a dry clean surface.
Do not remove the enamel back panel.
4.9 Use a damp cloth and mild non-abrasive cleaner on the
enamel back panel.
4.10 Carefully clean the burner and tray assembly using a
vacuum cleaner with soft brush attachment, ensure all
debris is removed from the burner ports.
4.11 Replace the white stones by referring to Section 5A.