Logic HE Conventional Flue Combined Controls Installation User Instructions
27
Remote Control
8.20 To turn the main burner of the appliance off using the hand-
set press and keep pressing the Off button ( ).
The main burner goes out leaving the pilot burning and ready
to operate .
Controls on Appliance
8.21 Use the controls on the appliance to turn the appliance off by
turning the left-hand control knob until it points to Off ( ).
A click is heard and the main burner goes out leaving the
pilot burning and ready to operate .
CAUTION: IN RARE INSTANCES, NOISES FROM
SOURCES OUTSIDE THE REMOTE CAN OPERATE THE
MAIN BURNER. IF THIS OCCURS, ALWAYS TURN THE
CONTROL TO PILOT ( ) OR OFF.
Slide Control
This appliance is operated using the slide control on the top
right hand side of the decorative front.
When the appliance is OFF the slide control will be at the
highest point, see Diagram 40.
40
OFF
Ignition Point
Low Setting
High Setting
Lighting the Pilot
8.22 Push the slide control down as far as possible to its lowest
point, see Diagram 39, this is the ignition point.
Keep the slide control pressed down for 5 seconds to
ensure the pilot is lit. Then release.
The appliance should light on its lowest setting.
8.23 When released the slide control automatically raises to a
natural stop point, see Diagram 40.
Repeat the above steps if the appliance does not light.
8.24 If, after repeating the above steps the pilot does not light,
contact your Retailer or Installer.
Installation Instructions
Adjusting the Flame height
8.25 Increase the flame height and temperature by carefully
moving the slide control up until the next stop point is felt,
see Diagram 40. This denotes the highest setting.
8.26 Carefully move the slide control down to the lower stop point
to return to the lowest setting.
YELLOW FLAMES APPEAR WHEN THE APPLIANCE
HAS REACHED SUFFICIENT HEAT – (10 TO 20
MINUTES).
IF THE APPLIANCE IS EXTINGUISHED OR GOES OUT IN
USE, WAIT 3 MINUTES BEFORE TRYING TO RELIGHT.
Switching OFF the Appliance
8.27 To turn the appliance off lift the slide control to its highest
stop point, see Diagram 40. The pilot goes out.