Stockton Inset Front Installation User Instructions

3
Installation Instructions/ User Instructions
All Models
To remove the door from the casting:
2.4 Open the door by turning the handle through 90° to the
right, see Diagram 3.
3
2.5 With the door open, support the front casting and lift off the
hinges by pulling upwards.
2.6 Place the front in position by locating the rear bracket over
the lugs on the top flange of the appliance, see Diagram 4.
4
2.7 Secure to both sides of the appliance with the 2 pozidriv
screws supplied, see Diagram 5.
5
2.8 Replace the door by slotting the hinge pins into the hinge
blocks.
Ensure the hinge pins are pushed fully down.
6
2.9 Close the door and turn the handle through 90° to lock in
position, see Diagram 6.
2.10 Unpack the ash cover.
2.11 Place in position by sliding the hooks through the slots in the
bottom of the front casting, see Diagram 7.
7
2.12 Adjust the ash cover until it rests flat against the front.
2.13 Ensure the front is secure and show the customer how to
remove the ash cover.
3. Control & Battery Access
3.1 Lift the ash cover off the Inset Front to access the controls
and batteries.
Details of the controls (and Replacing Batteries, if
applicable) are given in the User Section of the installation
Instructions supplied with the appliance.
4. Cleaning the Frame
Only clean the frame when it is cold.
4.1 The frame should be cleaned using a soft damp cloth and
buffed with a lint free duster.