Steel Frame Installation User Instructions
2
User Instructions
1. Operation
1.1 To open the decorative frame, gently lift the right-hand side
of the front and pull towards you. The door opens on the
hinges allowing access to the controls and window frame
assembly.
1.2 To close the decorative frame, push the front door until
the front tabs locate in the slots on the back panel and the
magnets retain the door in position.
PLEASE NOTE THAT SOME SLIGHT RESISTANCE
FROM THE LOCK MECHANISM IS NORMAL DURING
THE OPENING AND CLOSING OF THE DOOR.
BECAUSE THE DOOR IS QUITE HEAVY, THE TABS AND
SLOTS ENABLE THE DOOR TO ALWAYS REST IN A
HORIZONTAL POSITION WHEN CLOSED.
2. Controls & Battery Access
2.1 Open the frame as instructed in section 1 above.
2.2 Detailsofthefire’scontrolsaregivenintheUsersectionof
the Instruction manual supplied with the appliance.
Details for replacing Batteries can be found in the
upgradeable control manual.
3. Cleaning the frame
3.1 The frame should be cleaned using a damp cloth and buffed
with a lint free duster.
Installation Instructions
Covering Model 8695IR
1. General
1
Front of the Steel frame
31mm
850mm
667mm
1.1 These instructions are supplemental to and must be read in
conjunction with the Installation Instructions supplied with
the appliance. Read both thoroughly before installation.
1.2 Fitting of this decorative front should be carried out after the
appliance has been installed and commissioning tests
completed.
1.3 Diagram 1 shows the front view, the approximate
dimensions of the frame and its side view.
2. Fitting the frame
IMPORTANT: BEFORE PROCEEDING WITH THE
INSTALLATION, YOU MUST ENSURE THAT THE
WALL AREA ABOVE AND TO THE SIDE OF THE
FIRE IS STRONG ENOUGH TO SUPPORT THE
FIXINGS THAT CARRY THE WEIGHT OF THE
FRONT.
IF THE WALL IS CONSTRUCTED FROM HOLLOW
MATERIALS, IT IS ESSENTIAL THE BATTENS ARE
LOCATED TO THE SIDES OF THE FIRE TO
PROVIDE STRENGTH TO THE FIXINGS, DIAGRAM
2. DUE CONSIDERATION SHOULD BE TAKEN TO
ENSURE COMBUSTIBLE MATERIALS ARE
SUFFICIENT DISTANCE FROM THE APPLIANCE.
There are two methods of installation:
Hearth Mounted - does not require any additions to the
frame.
Wall Mounted - Requires the addition of an angled cover
strip (supplied).
Hearth Mounted
2.1 Your battens must be positioned so that fixings can be used
at 158.5mm distance from the flange of the appliance.
Your batten width must not come closer than 110mm to
the appliance flange, Diagram 2.
UserInstructions/InstallationInstructions