Logic HE Range Conventional Flue Log Effect Installation User Instructions

35
Servicing Instructions - Replacing Parts
4.2 Remove the decorative lip from the front of the fire, see
Diagram 5.
5
Slide Control
model shown
4.3 Lift the left hand side of the burner tray to disengage from
the injector, before lifting the right hand side, see Diagram 6.
6
Slide Control
model shown
4.4 Slide the burner tray fully to the left and remove through the
front of the firebox, see Diagram 6.
5. Control Assembly
5.1 Isolate and disconnect the gas supply at the Isolation elbow.
5.2 Remove the 2 wing nuts, see Diagrams 7 & 8.
7
Screw
Screw
Wing Nut
Wing Nut
Slide Control
8
Screw Screw
Wing Nut
Remote Control
5.3 Remove the 2 screws, see Diagrams 7 & 8.
Slide Control only
5.4 Remove the M4 lock nut and spacer securing the slider arm
to the appliance and loosen the 2 nuts, see Diagram 9.
Ensure that the spacer is retained and replaced when
the control assembly is reinstalled.
9
M4 Lock Nut and spacer
Nuts
All Models
5.5 Lift the control assembly, move to the left and angle
forward to remove through the front of the firebox, see
Diagrams 10 & 11.
10
Slide Control
11
Remote Control
Take care not to damage the liners.