Logic HE Balanced Flue Log Installation User Instructions

5
User Instructions
2a.2 There are a series of buttons on the left hand side of the
Control Box, see Diagram 2.
2
Power Switch
Power Button
Flame Adjustment (Up)
Flame Adjustment (Down)
To operate the appliance the white Power Switch on the
Control Box must be switched ON.
Note: The white Power Switch does not need to be
turned off each time the appliance is not in use.
However, if the appliance is left unattended for long
periods of time (e.g. vacation), it is recommended
to place the Power Switch into the off position.
Turning the appliance on:
2a.3 Press and hold the Power Button for 1 second and release.
The burner will light within 2 seconds.
2a.4 Use + and - buttons to adjust the flame height between
Minimum and Maximum.
Turning the appliance off
2a.5 Press the power button to turn the appliance off.
IMPORTANT: YELLOW FLAMES TYPICALLY
APPEAR WHEN THE APPLIANCE HAS REACHED
NORMAL OPERATING TEMPERATURE. THIS CAN
TAKE UP TO 30 MINUTES.
WARNING: IF THE APPLIANCE FAILS TO LIGHT OR
BECOMES EXTINGUISHED IN USE, WAIT 3
MINUTES BEFORE ATTEMPTING TO RELIGHT.
THE APPLIANCE MAY TAKE SEVERAL AUTOMATIC
ATTEMPTS TO RESTART.
DO NOT INTERRUPT THE VALVE DURING THIS
PROCESS.
2b. Remote Control
To operate the appliance the white Power Switch on the
Control Box must be switched ON.
To activate the Remote Control it will be necessary
to cradle the handset to unlock, see Diagram 3.
The green light will illuminate to show the handset
is ready to use.
IMPORTANT: Continue to cradle the handset
throughout an operation to keep it unlocked.
If the green light goes off during an operation it
will be necessary to reposition the handset so the
light comes back on and restart the operation.
3
Handset unlocked
(when illuminated)
Handset Features
4
Battery status
Light Sensor
(for display light)
Day of the week
Appliance Status
Time (12 hour or
24 hour display)
Program Mode
Room
Temperature
Mode:
Man (Manual)
Zzz (Timer)
Thermostat or
Timed
In Range of appliance
(missing if not in or
appliance turned off).
Handset unlocked
(when illuminated)
Change Handset
Settings
Change Mode
Settings
Decrease Button
Increase Button
Power Button
The Icon at the bottom of the screen displays the battery
condition of both the batteries in the handset and in the
Control Box alternatively.
RC = Remote Control Handset and FC = Fire Control
(Control Box).
If the handset has been replaced or the fire has
been serviced, see Installation Section 11b to set
up the handset.