Logic HE Balanced Flue Log Installation User Instructions

28
Operating the Appliance
Turning the appliance on
11b.10 Press the Power Button until Pilot flashes on the display.
11b.11 Release the Power Button and the Flame symbol will
appear on the display.
If the button is held the command will be cancelled for
safety reasons.
11b.12 Holding the handset to unlock, use + and - buttons to adjust
the flame height between Minimum and Maximum.
Turning the appliance off
11b.13 Holding the handset to unlock, press the power button to
turn the appliance off.
IMPORTANT: YELLOW FLAMES TYPICALLY
APPEAR WHEN THE APPLIANCE HAS REACHED
NORMAL OPERATING TEMPERATURE. THIS CAN
TAKE UP TO 30 MINUTES.
WARNING: IF THE APPLIANCE FAILS TO LIGHT OR
BECOMES EXTINGUISHED IN USE, WAIT 3
MINUTES BEFORE ATTEMPTING TO RELIGHT.
THE APPLIANCE MAY TAKE SEVERAL AUTOMATIC
ATTEMPTS TO RESTART.
DO NOT INTERRUPT THE VALVE DURING THIS
PROCESS.
12. Slide Control
This appliance is operated using the slide control on the top
right hand side of the decorative front.
When the appliance is OFF the slide control will be at the
highest point, see Diagram 30.
30
OFF
Ignition Point
Low Setting
High Setting
Installation Instructions
Lighting the Pilot
12.1 Push the slide control down as far as possible to its lowest
point, see Diagram 30, this is the ignition point.
Keep the slide control pressed down for 5 seconds to
ensure the pilot is lit. Then release.
The appliance should light on its lowest setting.
12.2 When released the slide control automatically raises to a
natural stop point, see Diagram 30.
Repeat the above steps if the appliance does not light.
12.3 If, after repeating the above steps the pilot does not light,
contact your Retailer or Installer.
Adjusting the Flame height
12.4 Increase the flame height and temperature by carefully
moving the slide control up until the next stop point is felt,
see Diagram 29. This denotes the highest setting.
12.5 Carefully move the slide control down to the lower stop point
to return to the lowest setting.
IMPORTANT: YELLOW FLAMES TYPICALLY
APPEAR WHEN THE APPLIANCE HAS REACHED
NORMAL OPERATING TEMPERATURE. THIS CAN
TAKE UP TO 30 MINUTES.
WARNING: IF THE APPLIANCE FAILS TO LIGHT OR
BECOMES EXTINGUISHED IN USE, WAIT 3
MINUTES BEFORE ATTEMPTING TO RELIGHT.
Switching OFF the Appliance
12.6 To turn the appliance off lift the slide control to its highest
stop point, see Diagram 30. The pilot goes out.