Riva2 600 600HL Conventional Flue Installation Instructions

33
Servicing Instructions - Replacing Parts
2.13 Replace the 2 magnetic side trims.
NEVER OPERATE THE APPLIANCE WHEN THE GLASS
PANEL IS REMOVED OR BROKEN.
2.14 Replace the decorative front by referring to the separate
instructions supplied with the front.
NOTE: ENSURE THAT THE LOGS ARE POSITIONED
CORRECTLY, SEE INSTALLATION INSTRUCTIONS
SECTION 12. ONLY USE THE CORRECT AMOUNT OF
LOGS AS SPECIFIED IN THE DIAGRAMS.
2.15 The glass front must be refitted to the appliance following
cleaning or servicing.
3. Removing the Emberbed Vanity Trim
Remove the Glass Frame, see Section 2.
3.1 Carefully place the frame face down on a flat, soft surface.
3.2 Remove the 2 screws securing the Vanity Trim to the Glass
Frame, see Diagram 6.
6
The trim can now be removed.
NOTE: The trim holds the door glass in position.
Exercise caution when the trim is removed.
DO NOT move or lift the door frame without the trim in
place.
3.3 Replace in reverse order.
4. Baffle & Vermiculite Liners
4.1 To access the burner tray and interior workings of the
appliance it is necessary to remove the baffle and the side
liners.
Note: The rear liner does not need to be removed to service
the appliance.
4.2 Remove the decorative logs.
BAFFLE
The baffle must be removed before the liners can be taken
out of the appliance.
4.3 To do this undo the screws ( x2 600/ x3 600HL) securing it
to the roof of the firebox, see Diagram 7.
Screws
7
Riva2 600 shown
4.4 The baffle can now be removed by lowering the front edge
and pulling forward through the front of the appliance.
TAKE CARE NOT TO DAMAGE THE SIDE PANELS.
4.5 When replacing the baffle ensure that the 3 tabs fit into the
slots at the back of the appliance, see Diagram 8.
8