Riva2 600 Balanced Flue Installation Instructions

9
Advice on handling and disposal
of fire ceramics
The fuel effect and side panels in this appliance
are made from Refractory Ceramic Fibre (RCF), a
material which is commonly used for this
application.
Protective clothing is not required when
handling these articles, but we recommend you
follow normal hygiene rules of not smoking,
eating or drinking in the work area and always
wash your hands before eating or drinking.
To ensure that the release of RCF fibres are kept
to a minimum, during installation and servicing a
HEPA filtered vacuum is recommended to
remove any dust accumulated in and around the
appliance before and after working on it. When
servicing the appliance it is recommended that
the replaced items are not broken up, but are
sealed within heavy duty polythene bags and
labelled as RCF waste.
RCF waste is classed as stable, non-reactive
hazardous waste and may be disposed of at a
licensed landfill site.
Excessive exposure to these materials may
cause temporary irritation to eyes, skin and
respiratory tract; wash hands thoroughly after
handling the material.
5. Arrangement of Fuel Bed Components
LOGS MUST BE POSITIONED ACCORDING TO THE
FOLLOWING INSTRUCTIONS TO GIVE THE CORRECT
FLAME EFFECT.
5.1 Ensure the burner tray is clean and free from any debris.
5.2 The logs for the fuel bed are clearly individually labelled, see
Diagram 13.
13
J
A
C
F
E
B
5.3 There are raised studs and flat surfaces on the emberbed to
locate the logs, see Diagram 14.
14
F (1)
F (2)
A
B
E
J
C
5.4 Place the 2 large embers in the rear corners of the
emberbed, see Diagram 15.
15
5.5 Place the front of Log A on the raised stud on the left hand
side of the emberbed. The log follows the flat surface on the
emberbed, see Diagrams 14 & 16.
16
A
5.6 Place Log F behind Log A.
The rear edge of Log A locates in the cutout at the front of
Log F. Log F should create a continuous curve with Log A,
touching the rear panel and resting on rear bracket, see
Diagrams 14 & 17.
17
F
User Instructions