Riva2 600 Balanced Flue Installation Instructions

6b. Electrode

6.5 Pull the ignition lead off the electrode and undo the retaining

nut, see Diagram 20.

6.6 Replace with a new electrode. Do not over-tighten the nut;

this could break the component.

6.7 Replace the ignition lead.

6c. Pilot Injector

6.8 Undo the pilot pipe from the bulkhead and from the

underside of the pilot burner, see Diagram 21.

Nut

6.9 Remove the pipe and the injector drops out from the burner.

6d. Thermocouple

IMPORTANT The Ignition lead and the Thermocouple

need to be removed at the same time regardless of

which needs to be replaced.

6.10 Unplug the Ignition lead from the electrode and undo the

brass nut to remove the thermocouple from the pilot burner

unit, see Diagram 18.

6.11 Undo the brass nut from the back of the interrupter block to

disconnect the thermocouple, see Diagram 22.

Nut

Interrupter Block

6.12 Unplug the Ignition lead from the control box, see Diagram 23.

Ignition Lead

6.13 Carefully cut cable ties from the vidaflex.

IMPORTANT Ensure not to cut the cables.

6.14 Remove screw and sealant from plate, see Diagram 24.

6.15 Feed ignition lead and thermocouple complete with vidaflex

through metal plate.

6.16 Withdraw ignition lead and thermocouple from vidaflex

sleeve. THIS MUST BE KEPT AND ASSEMBLED ON THE

NEW LEAD. A CABLE TIE MUST ALSO BE USED TO

RETAIN THE SLEEVE.

Servicing Instructions - Replacing Parts