Riva2 600 Balanced Flue Installation Instructions

30
11.8 Place the front of Log J on the raised stud on Log C. The
back of the log rests on the lower section of the rear bracket
and touches the rear panel, see Diagram 48.
48
J
11.9 Place the rear of the Log E on the raised stud on Log J. The
right hand side rests on the flat surface on the emberbed,
see Diagrams 43 & 49.
49
E
11.10 Log B locates on the raised stud on Log A and rests on the
flat surface on the emberbed, see Diagrams 43 & 50.
50
B
11.11 Place the 5 small embers in the locations shown in
Diagrams 51.
51
11.12 Sparingly spread an amount of the Embaglow bres
provided, covering the ports in the burner tray,
see Diagram 52.
Ensure the material is placed loosely to create a random
glow.
Take care not to use more than half a packet per application.
WARNING - DO NOT PLACE NEAR THE PILOT AREA.
52
12. Completion of Assembly
Ensure that the rope seal on the back of the glass frame
is intact.
12.1 To replace the glass frame, position so the hooks on the
back of the frame fit over the side pins, see Diagram 53.
53
12.2 Push the handle down.
12.3 Replace the screws. As the screws are tightened the glass
frame is pulled down against the hooks and forms a seal.
Replace ALL of the securing screws ensuring that a
screw is present in all fixing slots.
UNDER NO CIRCUMSTANCES SHOULD THE
APPLIANCE BE USED IF ANY OF THE GLASS
FRAME RETAINING SCREWS ARE LOOSE OR
MISSING.
12.4 Connect the battery lead to the battery pack attached to the
lower slotted trim.
PLEASE ENSURE NO WIRES ARE TRAPPED
BEFORE REPLACING THE LOWER SLOTTED
TRIM. THE LEADS ARE EASILY DAMAGED.
Installation Instructions