Riva2 600 Balanced Flue Installation Instructions

29
11. Arrangement of Fuel Bed Components
LOGS MUST BE POSITIONED ACCORDING TO THE
FOLLOWING INSTRUCTIONS TO GIVE THE CORRECT
FLAME EFFECT.
11.1 Ensure the burner tray is clean and free from any debris.
11.2 The logs for the fuel bed are clearly individually labelled, see
Diagram 42.
42
J
A
C
F
E
B
11.3 There are raised studs and flat surfaces on the emberbed to
locate the logs, see Diagram 43.
43
F (1)
F (2)
A
B
E
J
C
11.4 Place the 2 large embers in the rear corners of the
emberbed, see Diagram 44.
44
11.5 Place the front of Log A on the raised stud on the left hand
side of the emberbed. The log follows the flat surface on the
emberbed, see Diagrams 43 & 45.
45
A
11.6 Place Log F behind Log A.
The rear edge of Log A locates in the cutout at the front of
Log F. Log F should create a continuous curve with Log A,
touching the rear panel and resting on rear bracket, see
Diagrams 43 & 46.
46
F
11.7 Place Log C on the raised stud in the centre of the
emberbed, with the right end resting in the groove, see
Diagrams 43 & 47.
47
C
Installation Instructions