Riva2 600 Balanced Flue Installation Instructions

2020
Installation Instructions
3.11 Mark around the flue, see Diagram 2.
2
10mm
A wall plate is supplied to fix the flue to the wall:
3.12 Bend the tab to 90°.
3.13 Assemble the plate onto the flue but do not secure to wall
until the flue is fully assembled.
3.14 The cardboard fitment in the terminal is used to support the
flue whilst it is cut to length. ONCE CUT TO SIZE REMOVE
THE CARDBOARD REMNANT, see Diagram 3.
3
4. Removing the Glass Frame
4.1 Remove the glass frame by removing the 2 side trims, see
Diagram 4. These are held on by magnets.
4
4.2 Lift out the bottom slotted trim, see Diagram 5.
Note the orientation of the metal shield for reassembly.
5
4.3 Disconnect the battery lead from the battery pack attached to
the lower slotted trim, see Diagram 6.
6
4.4 Remove the screws at the base of the glass frame,
see Diagram 7 A.
7
A
A
B
A
4.5 Pull up the handle at the front, see Diagram 7 B.
4.6 Whilst supporting the top, lift the glass frame using the
handle, up and over the lower edge, see Diagram 8.
8