Riva2 600 Balanced Flue Installation Instructions

5.7 Place Log C on the raised stud in the centre of the

emberbed, with the right end resting in the groove, see

Diagrams 14 & 18.

5.8 Place the front of Log J on the raised stud on Log C. The

back of the log rests on the lower section of the rear bracket

and touches the rear panel, see Diagram 19.

5.9 Place the rear of the Log E on the raised stud on Log J. The

right hand side rests on the flat surface on the emberbed,

see Diagrams 14 & 20.

5.10 Log B locates on the raised stud on Log A and rests on the

flat surface on the emberbed, see Diagrams 14 & 21.

5.11 Place the 5 small embers in the locations shown in

Diagrams 22.

5.12 Sparingly spread an amount of the Embaglow bres

provided, covering the ports in the burner tray,

see Diagram 23.

Ensure the material is placed loosely to create a random

glow.

Take care not to use more than half a packet per application.

WARNING - DO NOT PLACE NEAR THE PILOT AREA.

User Instructions