Riva2 600 600HL Conventional Flue Installation Instructions

28
Installation Instructions
13. Completion of Assembly
Ensure that the rope seal on the back of the glass frame
is intact.
13.1 To replace the glass frame, position so the hooks on the
back of the frame fit over the side pins, see Diagram 57.
57
13.2 Push the handle down.
13.3 Replace the screws. As the screws are tightened the glass
frame is pulled down against the hooks and forms a seal.
Replace ALL of the securing screws ensuring that a
screw is present in all fixing slots.
UNDER NO CIRCUMSTANCES SHOULD THE
APPLIANCE BE USED IF ANY OF THE GLASS
FRAME RETAINING SCREWS ARE LOOSE OR
MISSING.
13.4 Connect the battery lead to the battery pack attached to the
lower slotted trim.
PLEASE ENSURE NO WIRES ARE TRAPPED
BEFORE REPLACING THE LOWER SLOTTED
TRIM. THE LEADS ARE EASILY DAMAGED.
13.5 Replace the lower trim, ensuring that the angled metal
shield is sloping towards the door frame.
13.6 Replace the 2 magnetic side trims.
NEVER OPERATE THE APPLIANCE WHEN THE GLASS
PANEL IS REMOVED OR BROKEN.
13.7 Replace the decorative front by referring to the separate
leaflet supplied with the front.
NOTE: ENSURE THAT THE LOGS ARE POSITIONED AS
ABOVE. ONLY USE THE CORRECT AMOUNT OF LOGS
AS SPECIFIED IN THE DIAGRAMS.
14. Lighting the Appliance
The appliance is operated by thermostatic remote control.
58
This remote controls the appliance from pilot ignition through
to shut down.
In ‘MANUAL MODE’ you can:
— light the pilot
— turn on the main burner
— regulate the flame from low to high and back
— turn off the burner leaving just the pilot burning
In ‘TEMP MODE’ you can:
— set the room temperature so the stove automatically
maintains that temperature
In ‘TIMER MODE’ the appliance:
— turns on and off according to the set time periods
— automatically regulates the room temperature during
the set periods
14.1 Turning the appliance On
Your remote can control the gas appliance from pilot ignition
through to shut down.
To turn the appliance on press the OFF button and the UP
button simultaneously. You hear several short signals.
The pilot and main burner ignite and the remote is now
in Manual Mode:
Turning the appliance Off:
Press the OFF button to turn the appliance off
FOR SAFETY, YOU MUST WAIT 30 SECONDS BEFORE
LIGHTING THE APPLIANCE AGAIN.
IMPORTANT: YELLOW FLAMES TYPICALLY
APPEAR WHEN THE APPLIANCE HAS REACHED
NORMAL OPERATING TEMPERATURE. THIS CAN
TAKE UP TO 30 MINUTES.
WARNING: IF THE APPLIANCE FAILS TO LIGHT OR
BECOMES EXTINGUISHED IN USE, WAIT 3
MINUTES BEFORE ATTEMPTING TO RELIGHT.
FOR FULL OPERATING INSTRUCTIONS AND
TROUBLESHOOTING SEE USER SECTION.