Riva2 600 600HL Conventional Flue Installation Instructions

26
Installation Instructions
12. Arrangement of Fuel Bed Components
LOGS MUST BE POSITIONED ACCORDING TO THE
FOLLOWING INSTRUCTIONS TO GIVE THE CORRECT
FLAME EFFECT.
12.1 Ensure the burner tray is clean and free from any debris.
12.2 The logs for the fuel bed are clearly individually labelled, see
Diagram 46.
46
L
A
B
D
C
J
12.3 There are raised studs and flat surfaces on the emberbed to
locate the logs, see Diagram 47.
47
L
A
B
D
C
12.4 Place Log C on the stud in the centre of the burner, see
Diagrams 47 & 48.
48
C
12.5 Place the front of Log J on the raised stud on Log C. The
back of the log rests on the rear bracket and touches the
pilot bracket, see Diagram 49.
49
J
12.6 Rest the left hand side of Log D on Log J. The right hand
side rests on the flat surface on the burner tray, see
Diagrams 47 & 50.
50
D
12.7 Place the front edge of Log A in the indent on the burner
tray. The log rests on the flat surface on the burner tray, see
Diagrams 47 & 51.
51
A