Riva2 600 600HL Conventional Flue Installation Instructions

16
Installation Instructions
1. Safety Precautions
1.1 For your own and other’s safety, you must install this
appliance according to local and national codes of practice.
Failure to install the appliance correctly could lead to
prosecution. Read these instructions before installing
and using this appliance.
1.2 These instructions must be left intact with the user.
1.3 Do not attempt to burn rubbish on this appliance.
1.4 Keep all plastic bags away from young children.
1.5 Do not place any object on or near to the appliance and
allow adequate clearance above the appliance.
IF THE APPLIANCE IS EXTINGUISHED OR GOES OUT
IN USE, WAIT 3 MINUTES BEFORE ATTEMPTING TO
RELIGHT THE APPLIANCE.
1.6 The appliance is fitted with an oxygen sensitive pilot that will
act to cut off the gas supply to the appliance in the event of
incorrect operation of the flue.
If the system acts to shut off the gas supply, this indicates
that there is insufficient flue pull. Continued operation of this
safety device means that there may be a serious problem
with the flue system, and this should be inspected by a
qualified gas engineer. Do not use the appliance until an
engineer says it is safe to do so.
The oxygen sensitive pilot must not be tampered with. Use
only genuine Gazco replacement parts when servicing the
appliance - refer to Servicing section.
IMPORTANT: REFER TO DATA BADGE AND
TECHNICAL SPECIFICATION AT THE FRONT OF THE
MANUAL TO ENSURE THE APPLIANCE IS
CORRECTLY ADJUSTED FOR THE GAS TYPE AND
CATEGORY APPLICABLE IN THE COUNTRY OF USE.
FOR DETAILS OF CHANGING BETWEEN GAS
TYPES REFER TO SERVICING, SECTION 12,
REPLACING PARTS.
Unpacking
1.7 Remove the appliance from its packaging, and check that it
is complete and undamaged.
Put the loose ceramic parts to one side so that they are not
damaged during installation.
2. Installation of the Appliance
2.1 This appliance can be installed in four different ways:
1) Builder’s opening with an Edge finish.
2) Builder’s opening with a decorative front.
3) Stud work with an Edge finish.
4) Stud work with a decorative front.
Flue Attachment
For additional information please refer to Site Requirements
section, page 14.
Options 1 and 2 above can be:
— Top exit with a liner - 5" (127mm)
— Rear exit without a liner - 7" (178mm) minimum
2.2 The appliance is supplied with a flue fixing plate to attach
the flue liner to the appliance within the aperture.
2.3 Locate the flue liner in position and place the flue securing
clip over the liner, push the end of the liner over the outside
of the spigot and secure by tightening the securing clip, see
Diagram 1.
1
2.4 Place the liner in its final position ensuring that the sliding
flue plate rests at the correct height in the opening, and that
the front flange of the plate rests against the outside face at
the top of the opening.
2.5 When installing the appliance into a masonry chimney
without a liner, it must be converted to a rear exit.
2.6 Remove the 2 fixing screws securing the spigot assembly.
2.7 Slide the blanking plate into the guides.
2.8 Replace the 2 fixing screws, see Diagram 2.
2