Icon XS Riva2 Frame Installation User Instruction

3
Installation Instructions
2. Fitting the Sub-Frame
2.1 Complete the installation of the appliance by following the
Installation Instructions supplied with the appliance.
2.2 There are two different fitting methods depending on the
appliance purchased.
Follow the relevant sections below.
Riva2 400, 500, 500HL, 600, 600HL, 750
& Reflex 75T
2.3 Offer the wall mounting brackets to the appliance and
position so the interior edges of the sub-frame sit flush with
the edges of the appliance flange, see Diagram 1.
1
2.4 Mark the position for the 6 fixing screws.
2.5 Remove the mounting brackets and drill the fixing holes and
fill with rawl plugs.
2.6 Attach the mounting brackets to the wall using the screws
provided.
Riva2 800, 1050, & Reflex 105
NOTE: MUST BE FITTED AS AN EDGE
INSTALLATION.
2.7 The position for the side mounting brackets are determined
by the position of the lower bracket to the appliance.
RIVA2 800 ONLY:
2.8 Offer the bracket to the appliance and position so the top of
the bracket is central in front of the appliance and level with
the top of the flange, see Diagram 2.
2
Detail A
RIVA2 1050 & REFLEX 105 ONLY:
2.9 Offer the bracket to the appliance and position so the top of
the bracket is central in front of the appliance and ensure
that a 12mm gap is left between the top of the flange and
the top of the lower opening lip, see Diagrams 3 & 4.
3
Detail A
4
12mm gap
RIVA2 800, 1050 & REFLEX 105:
2.10 Mark the position for the 2 screw holes.
2.11 Remove the bracket and drill the fixing holes.
2.12 Fill with rawl plugs before securing the bracket to the wall.
2.13 Fit the side mounting brackets in place using the cut outs to
fit over the lower bracket tabs, see Diagram 2 Detail A.
2.14 Mark the position for the 6 fixings screws.
2.15 Remove the mounting brackets and drill the fixing holes and
fill with rawl plugs.
2.16 Attach the mounting brackets to the wall using the screws
provided.