Esprit Front Installation User Instructions

3
Installation Instructions
The Esprit consists of 6 main components:
2
Tall Support Frame
Small Section
Tall Section
Centre Infills
Small Support Frame
Fixing kit containing
6 x No.8 self tapping screws
2 x Locking Brackets
16 x No.8 Dome Woodscrews
16 x No.8 Rawlplugs
1 x Instruction manual
Using the components above 2 decorative options can be
achieved, see Diagram 3.
3
Option 1
Option 2
The Support Frames have locating tabs on both the top and
bottom to enable them to be positioned either above or
below the appliance in order to achieve the desired effect.
IMPORTANT: Ensure the Support Frames are tted
in the correct orientation for the decorative option
required, see Diagram 2.
2. Pre-Installation
Before installing the appliance the following needs to be
calculated:
2.1 Decide on the decorative option required, see Diagram 3.
2.2 Decide on the height from the floor/hearth level to the
bottom of the decorative front (recommended 5mm minimum
clearance).
Add the desired distance between the bottom of the
decorative front and floor/hearth level to distance between
the bottom of the decorative front and the bottom of the
firebox, see below.
Option 1 Option 2
120 406
This gives the total distance from the floor/ hearth to the
base of the appliance firebox required when installing the
Riva2 500HL, see Diagram 4.
406
Minimum 5mm
Base of the
Appliance Firebox
Floor/ Hearth
Level
4
2.3 Complete the installation of the appliance by following the
Installation Instructions supplied with the appliance.