Richmond Frames Installation User Instructions

2
1. General
1.1 These instructions are supplementary to, and must be read
in conjunction with, the installation instructions supplied with
the appliance. Read both thoroughly before installation.
VFC Convector
Note: The VFC requires a bracket to be fitted to the
appliance before installation.
Ensure that the commissioning tests are carried out AFTER
the fitting of the front.
Logic HE/ E-Box
Fitting of this decorative front is to be carried out after the
appliance has been installed.
Ensure that the commissioning tests are carried out
BEFORE fitting the front.
1.2 Ensure that the supplementary sheet is attached to the
installation instructions and leave with the user.
2. Fitting for 16" VFC Convector
2.1 Position the bracket onto the three lugs on top of the
convector - ensure that it engages completely.
2.2 Secure the bracket using the self-adhesive metal tape
provided.
1
2.3 Push the convector back into position according to the
installation instructions provided with the gas appliance.
2.4 Secure the convector with the four screws provided with the
convector, see Diagram 2.
2
2.5 Hang the casting onto the bracket - ensure that it engages
securely, see Diagram 3.
3
2.6 Secure the castings at the bottom using the two screws
provided, see Diagram 4.
4
Installation Instructions
Covering frame model numbers:
Model
Logic HE Coal (Manual & Remote only) 8679
E-Box
TM
8679
16" VFC Convector 8678