Logic HE Range Conventional Flue Log Effect Installation User Instructions

40
Servicing Instructions - Replacing Parts
LINERS
Once the baffle has been placed carefully to one side the
liners can then been taken out in the following order.
12.4 To remove the Right Hand liner first tilt inwards towards the
centre of the firebox before lifting up and pulling out through
the front of the firebox, see Diagram 32.
32
12.5 To remove the Left Hand liner first tilt inwards towards the
centre of the firebox before lifting up and pulling out through
the front of the firebox, see Diagram 32.
The 2 side liners also support the rear liner.
Taking out the side liners will allow the rear liner to drop
down so ensure it is supported.
12.6 Remove the rear liner by carefully lifting over the bottom
bracket and twisting slightly to allow it to be removed
through the front of the appliance, see Diagram 33.
33
12.7 To replace the liners and baffle reverse these procedures.
13. Changing between Gas Types
In order to change between gas types, it will be necessary
to change the Gas Valve, Pilot, Injector, Burner, &
Databadge.
Note: The Control Box will be set for the particular
appliance and gas type. In all instances, when ordering
new parts, be sure to quote the appliance type and serial
number.
Use only genuine Gazco replacement parts.
Nonstandard components will invalidate the guarantee
and may be dangerous.
14. Debris Collection
14.1 Remove the frame from the appliance by referring to the
separate instructions supplied with the front.
14.2 Remove the glass frame, see Section 2 and the fuel bed
components. Place carefully to one side.
14.3 Remove the baffle and liners, see Section 12.
14.4 Remove the main burner, see Section 4.
14.5 Remove the Control Assembly, see Section 5.
14.6 Undo the screws and remove the convector air panel, see
Diagram 34.
34
14.7 Pull the top of the air panel forwards to release, then tilt the
bottom edge upwards into the firebox to remove.
14.8 Remove the appliance from the fireplace opening noting the
installation method.
14.9 Clean out any debris.
14.10 Replace the appliance into the opening and securing using
the chosen method as described in the installation section.
14.11 To replace the convector air panel:
Angle the top edge of the panel up and under the lip at the
back of the firebox.
Clip the panel into place and secure with the 2 previously
removed screws.