Logic HE Balanced Flue Log Installation User Instructions

1. Commissioning

1.1 Complete the Commissioning Checklist at the front of this

manual covering:

— Thermocouple soundness checks.

This is to include ensuring the thermocouple is secure on

the pilot bracket assembly, lead connection and integrity.

— Flue checks

— Gas checks

— Fuel effect layout - flame picture

1.2 Upon completion of the commissioning and testing of the

installation and correct operation of the appliance, the

installer must instruct the user how to operate the appliance.

1.3 Guide the user through the User Instructions paying

particular attention to:

a) Regular servicing (Section 10 of the User Instructions).

b) Ventilation (Section 11 of the User Instructions) - point out

the ventilation positions where applicable.

c) Hot surfaces (Section 13 of the User Instructions).

Commissioning

2. Pairing the Appliance

(Remote Version Only)

It may be necessary to pair the handset to the appliance

following servicing.

2.1 Ensure the white Power switch on the Control Box is in the

ON position.

2.2 Cradle the handset to unlock.

The green light must be illuminated for the handset to

accept commands.

2.3 Simultaneously press and hold the - and + buttons on the

Control Box, until the red light flashes on the Control Box.

2.4 Immediately press the Power Button on the Control Box.

The handset emits a short beep, the green light on the

handset flashes and the following icon is displayed, see

Diagram 1.

2.5 With the display showing the icon press and hold the SET

button to pair the handset to the appliance.

2.6 Following new pairing it will be necessary to set the time

and date, see Installation Instructions, Section 11b.

If too much time passes without the SET command the

display will show the following, see Diagram 2.

The handset has not paired and the process will need to be

started again.