Reflex 75T Multi Sided Balanced Flue Installation Manual

50
Upper Side Brackets
Lower Side Brackets
2
1.
2.
3.
3
Ensure that no fuel effect has fallen into the side glass
channels.
To Replace:
Place the Side Glass panel in position. Do not tighten the brackets
at this stage.
Replace the Front Glass Panel and tighten the front brackets,
ensuring the Side Glass sits on the spring clip located in the rear
channel.
Push the rear side brackets up against the side glass and tighten
the screws. Ensure the side glass locates behind the front glass
panel.
Tighten the top and bottom side glass brackets.
Replace the magnetic trim.
REPLACING THE POWER CABLE
BEFORE UNDERTAKING ANY WORK SWITCH OFF THE
APPLIANCE AND ISOLATE THE POWER SUPPLY ENSURING
THERE IS NO POWER TO THE APPLIANCE.
To replace the Power Cable first remove the Main Control
Assembly.
Disconnect the 3 cables from the Power Module, Arrow A.
NOTE THE CONFIGURATION OF THE WIRES.
A
B
Remove the nuts from the Earth stud and remove the two Ring
Terminals, Arrow B.
Loosen the locking screw securing the Power Cable in place.
Withdraw the old cable.
Fit the new cable in reverse order ensuring it is rewired in the
original conguration.
SERVICING INSTRUCTIONS