Reflex 75T Multi Sided Balanced Flue Installation Manual

49
1
2
5
To replace the Liners reverse these procedures. Ensure no amber
glass or black shale has fallen onto the side liner inll or liner
support brackets.
To Replace the Side Glass:
Place the Side Glass panel in position. Do not tighten the brackets
at this stage.
Replace the Front Glass Panel and tighten the front brackets,
ensuring the Side Glass sits on the spring clip located in the rear
channel.
Push the rear side brackets up against the side glass and tighten
the screws. Ensure the side glass locates behind the front glass
panel.
Tighten the top and bottom side glass brackets.
Replace the magnetic trim.
BAFFLE
Remove the Front Glass, Fuel Effect, and Main burners.
Remove the Rear Liner and Side Liner (if applicable).
The Bafe is held in position by 10 screws.
1
Front of appliance
Underside of Bafe
2
Replace in reverse order.
SIDE GLASS PANELS
THE SIDE GLASS DOES NOT NEED TO BE REMOVED
TO SERVICE THE APPLIANCE.
It is recommended to leave the Side Glass in situ unless
absolutely necessary.
The Front Glass must be removed in order to take out the Side
Glass panels.
Loosen
1
SERVICING INSTRUCTIONS