Reflex 75T Multi Sided Balanced Flue Installation Manual
47
CROSS LIGHTING INJECTOR
Remove the Magnetic Trim, Front Glass, Log Burners and Main
Control Assembly
Turn the Main Control Assembly over to access the components on
the underside.
Remove the injector pipe by loosening the two nuts.
Undo the nut from the Cross Lighter.
Turn the Main Control Assembly over.
Withdraw the Cross Lighting bar from the Control Assembly.
The Injector is screwed into the bottom of the bar.
Replace with the correct size Injector and ret all components in the
reverse order.
Check for leaks.
LATCHING SOLENOID
Remove the Magnetic Trim, Front Glass, and Main Control
Assembly.
Remove the cradle holding the rear LEDs to access the pipe work
for the solenoid.
Undo the three nuts shown and free the solenoid from the
pipework.
A
Remove the Solenoid plug from the Control Box,
see Diagram 35, Arrow A.
Cut the cable tie. NOTE the orientation of the cables.
Replace in reverse order.
Check for leaks.
Ensure that the cable ties are replaced.
CHANGING BETWEEN GAS TYPES
In order to change between gas types, it will be necessary to
change the following components:
Pilot Injector
Main Injectors x 6
Cross lighting Injector
Gas Valve
Main Burner x 3
Contact your Gazco retailer for further information.
A kit of parts is available for this. Always quote the Model number
and Serial number when ordering any spare parts.
SERVICING INSTRUCTIONS