Reflex 75T Multi Sided Balanced Flue Installation Manual

41
SERVICING INSTRUCTIONS
REMOVING THE FUEL EFFECT
The fuel effect consists of 12 different components:
— 5 Logs
— 3 Large embers
— 2 Small embers
— Shale effect & amber effect
To avoid damage Logs A, B, C and D should be removed in the
following order and placed on a dry, clean surface.
Remove Logs D, B and C.
B
C
D
Slide Log A backwards, from under the centre Log Burner, to
remove.
A
Remove the remaining components:
1. Log E.
2. Embers F, G and H.
3. 2 small Embers.
4. Shale Effect.
5. Amber Effect.
Keep each component separate for ease of replacing.
When replacing the fuel effects see Installation Section for
layout instructions.
REMOVING THE LOG BURNERS
AND MAIN CONTROL ASSEMBLY
Remove the Front Glass.
Remove the Fuel Effect.
1
2
Loosen Rear Screws
Remove Front Screws
3
NOTE: The left and right hand screws secure the 2 lower liner tabs.
Slide the Mesh Tray forward slightly to disengage from the rear
screws and carefully lift over the Log Burner Brackets, Pilot and
Cross Lighter.
Remove through the front of the appliance.
WHEN REPLACING THE MESH TRAY TAKE CARE NOT TO
DAMAGE THE LOG BURNER BRACKETS, PILOT AND CROSS
LIGHTER. REPLACE THE FRONT SCREWS FIRST BEFORE
TIGHTENING THE REAR SCREWS.