Reflex 75T Multi Sided Balanced Flue Installation Manual

33
INSTALLATION INSTRUCTIONS
Connect the module lead to the Wi-Fi module.
LED's
2
Position the Wi-Fi module in the Wi-Fi module bracket.
Module Bracket
Receiver Location
3
The receiver is located beneath the Main Control Assembly, close
to the pilot area.
Using long nose pliers connect the other end of the module lead to
the receiver.
Note: Do not force the connector into position, ensure the
connector is at the correct orientation before inserting.
Ensure the module lead runs underneath the front panel spacer.
Front Panel removed for clarity
Front Panel Spacer
4
This should complete the wiring circuit as shown.
Wi-Fi
Router
Interrupter Leads
Wi-Fi Module
AUX Lead
Valve Lead
Ignition
Cable
Connecting Wire
Lighting
Module
Mains
Lead
Smart Device
Wall Switch Lead
(not applicable)
5
NOTE: Ensure none of the wires are snagged or caught on
any internal components.
Follow the steps listed in the MyFire App Setup manual
PR2467 to connect a smart device to the fire.
Replace the Front Glass, Cam Lock Brackets, Glass Support
Bracket, and trims.
ENSURE THAT THE GLASS BRACKETS ARE SECURE AND IN
THE ORIGINAL ORIENTATION.
The installation is now complete.
Once the Wi-Fi module has been installed and
connected to a power source there is a 24 hour
window to complete the setup process on the MyFire
app.
If setup is not completed in this window the Wi-Fi
module will have to be manually reset to complete
setup, see Page 34 & PR2467 MyFire App Setup.
Once tted, remove the trims to access the Wi-Fi module.