Reflex 75T Conventional Flue User Installation Manual
43
Servicing Instructions - Replacing Parts
16. Debris Area Access
16.1 Remove the decorative front from the appliance by referring
to the separate instructions supplied with the front.
16.2 Remove the Glass Frame and the fuel bed components,
see Sections 2 and 3. Place carefully to one side.
16.3 Remove the Main Control Assembly, see Section 4.
16.4 Undo the screws and remove the Convector Air Panel to
access the Debris Access Panel, see Diagram 36.
36
Screws
16.5 Undo the 7 screws to remove the Debris Access Plate,
see Diagram 37.
37
Screws
16.6 Clean out the debris.
16.7 Reassemble in reverse order.
17. Baffle
17.1 The Bafe must be removed before the Liners can be taken
out of the appliance.
BAFFLE
17.2 To do this undo the 5 screws securing it to the roof of the
rebox, see Diagram 38.
Screws
38
17.3 The Bafe can now be removed by lowering the front edge
and pulling forward through the front of the appliance.
TAKE CARE NOT TO DAMAGE THE SIDE PANELS.
17.4 When replacing the Bafe ensure that the 3 tabs t into the
slots at the back of the appliance, see Diagram 39.
39